How to Install GlusterFS on Arch Linux

GlusterFS is a distributed file system that is scalable and flexible. It allows you to store and access data from multiple servers as if it were a single volume. This tutorial will guide you through the steps required to install GlusterFS on Arch Linux.

Prerequisites

Before installing GlusterFS, make sure that your system meets the following minimum requirements:

Step 1: Add the GlusterFS Repository

To install GlusterFS, you need to add the GlusterFS repository to your Arch Linux system. To do this, you need to create a repository file using the following command:

sudo nano /etc/pacman.d/mirrorlist

Then add the following lines to the file:

[glusterfs]
Server = http://download.gluster.org/pub/gluster/glusterfs/9/LATEST/Arch
ValidSigKeys = F7FD5492264BB94D

Save and close the file by pressing Ctrl + X and then Y and Enter.

Step 2: Install GlusterFS

After adding the GlusterFS repository, you can now install GlusterFS on your Arch Linux system. To do this, execute the following command:

sudo pacman -S glusterfs

This command will install the GlusterFS package on your system along with its dependencies.

Step 3: Configure GlusterFS

After installing GlusterFS, you need to configure it to work properly. To do this, follow the steps below:

Create Volume Configuration File

First, create a volume configuration file by running the following command:

sudo nano /etc/glusterfs/glusterfs.vol

Then add the following lines to the file:

volume myvol
  type cluster/replicate
  option transport-type tcp
  option auth.allow 127.0.0.1
  option brick-changelog off
  option cluster.lookup-optimize on
  option network.remote-dio enabled
  subvolumes /mnt/brick1 /mnt/brick2
end-volume

Save and close the file by pressing Ctrl + X and then Y and Enter.

Create Bricks Directory

Next, create a directory for the bricks. To do this, execute the following commands:

sudo mkdir /mnt/brick1
sudo mkdir /mnt/brick2

Start the GlusterFS Service

Finally, start the GlusterFS service with the following command:

sudo systemctl start glusterd

Step 4: Verify GlusterFS Installation

To verify that GlusterFS has been installed correctly, you can check the service status by executing the following command:

sudo systemctl status glusterd

You should see a message that says the service is active and running.

Conclusion

Congratulations! You have successfully installed GlusterFS on your Arch Linux system, configured it, and verified that it is running properly. You can now use GlusterFS to store and access data from multiple servers.

If you want to self-host in an easy, hands free way, need an external IP address, or simply want your data in your own hands, give IPv6.rs a try!

Alternatively, for the best virtual desktop, try Shells!