How to install WireGuard on NetBSD

Introduction

WireGuard is a modern and highly-efficient VPN protocol that is designed with simplicity, encryption, and speed in mind. It is easy to set up and is available for multiple platforms, including NetBSD. In this tutorial, we will walk you through the steps to install and configure WireGuard on NetBSD.

Prerequisites

Before we dive into the installation process, there are a few things that you need to have:

1. Root Access to the NetBSD Server
2. A working internet connection
3. Basic knowledge of the NetBSD command line

Installing WireGuard

To install WireGuard on NetBSD, follow these steps:

1. Open the command line terminal on your NetBSD server.

2. Update the package repository index by running the following command:

   # pkgin update
   

3. Install WireGuard packages by running the following command:

   # pkgin install wireguard
   

4. Verify that the package is installed by running the following command:

   # wireguard --version
   

5. If the command above displays the version of WireGuard installed, then you have successfully installed WireGuard on NetBSD.

Configuring WireGuard

After installing WireGuard, the next thing you will need to do is to configure it.

1. Edit the configuration file (/etc/wireguard/wg0.conf) by running the following command:

   # vi /etc/wireguard/wg0.conf
   

2. Add the following content to the configuration file:

   [Interface]
   PrivateKey = <Private Key>
   ListenPort = <Port>
   Address = <IP Address of Server>
   
   [Peer]
   PublicKey = <Public Key of Peer>
   AllowedIPs = <IP Address of Peer>
   

   • Replace <Private Key> with the private key that you generated for your server.
   • Replace <Port> with the port that will be used by WireGuard.
   • Replace <IP Address of Server> with the IP address of your server.
   • Replace <Public Key of Peer> with the public key of the peer you want to connect to.
   • Replace <IP Address of Peer> with the IP address of the peer you want to connect to.

3. Save and close the configuration file.

4. Start the WireGuard service by running the following command:

   # wg-quick up wg0
   

   This command will start the WireGuard service and create the tunnel.

Conclusion

Congratulations, you have successfully installed and configured WireGuard on NetBSD. You can now use the VPN tunnel to securely connect to your server or other remote servers. Remember to keep your private key secure and only share it with trusted parties.

If you want to self-host in an easy, hands free way, need an external IP address, or simply want your data in your own hands, give IPv6.rs a try!

Alternatively, for the best virtual desktop, try Shells!