Before proceeding with the installation process, you should make sure that you have the following:
To install Zenko CloudServer, you can use the Nix package manager. Run the following command:
sudo nix-env -iA nixos.zenko-cloudserver
The -i flag tells nix-env to install the package. The -A flag selects an attribute from the package set, which in this case is nixos.zenko-cloudserver.
After installing Zenko CloudServer, you need to configure it before you can use it. The configuration file is located at /etc/zenko/cloudserver.conf. You can open the configuration file by running the following command:
sudo nano /etc/zenko/cloudserver.conf
Once the file is open, you need to set the following values:
auth.accessKey: You can generate this key on the Amazon S3 website.auth.secretKey: You can generate this key on the Amazon S3 website.dataPath: The path where you want the data to be stored. You can use the default value or set your own path.endpoints: The endpoint URLs that you want to use to access the Zenko CloudServer. You can use the default value or set your own URLs.After making the necessary changes, save the file and exit nano.
After configuring Zenko CloudServer, you can start it by running the following command:
sudo systemctl start zenko-cloudserver
This command will start the Zenko CloudServer service.
After starting Zenko CloudServer, you can verify that it's running by running the following command:
curl http://localhost:8000
If Zenko CloudServer is running, you should see a message similar to the following:
{"code":200,"message":"Zenko CloudServer"}
Congratulations! You have successfully installed and configured Zenko CloudServer on NixOS Latest.
If you want to self-host in an easy, hands free way, need an external IP address, or simply want your data in your own hands, give IPv6.rs a try!
Alternatively, for the best virtual desktop, try Shells!
