Installing strongSwan on NixOS Latest

Introduction

StrongSwan is an open-source IPsec-based VPN solution that allows secure transmission of data over the internet. This tutorial will guide you on how to install StrongSwan on NixOS Latest.

Prerequisites

Before you proceed with the installation of StrongSwan, make sure your system is updated and has the basic development tools installed.

Installation

1. Open a terminal on your NixOS system.
2. Update your system using sudo nix-channel --update && sudo nixos-rebuild switch.
3. Use the following command to install StrongSwan: sudo nix-env -i strongswan.
4. Once the installation is complete, you can verify if the service is running correctly by running the following command: sudo systemctl status strongswan.
5. The output should show that the service is up and running.

Configuration

1. Navigate to the strongSwan configuration file using the following command: sudo nano /etc/strongswan.conf.
2. Modify the contents of the file to your preference.

Usage

1. To start the strongSwan service, run the following command: sudo systemctl start strongswan.
2. To stop the service, use the command: sudo systemctl stop strongswan.
3. You can also enable the service to start at boot by running: sudo systemctl enable strongswan.

Conclusion

You have successfully installed and configured StrongSwan on NixOS Latest. You can now use StrongSwan to secure your internet traffic by creating VPN connections.

If you want to self-host in an easy, hands free way, need an external IP address, or simply want your data in your own hands, give IPv6.rs a try!

Alternatively, for the best virtual desktop, try Shells!